Go PREMIUM to remove Ads


Posted by BILLIUM on 13 July 2020 - 18:37:50
Local Airport: MAN


Could anyone tell me what i would put for seeing planes at museums like Sinsheim and Speyer please has not sure what to put down.

Thanks Bill

Posted by Hitman69 on 14 July 2020 - 06:45:45
Local Airport: MAN

The site recommends using the code XMU for the airport and I would then put the museum name in the comments. If it's a museum at an airfield like Cosford or Duxford I just use the airfield code. Funny you should mention Sinsheim and Speyer in your post, I was at Sinsheim yesterday and I'm going to Speyer today.

Posted by BILLIUM on 14 July 2020 - 12:36:43
Local Airport: MAN

Hi Hitman69

Thanks for your help with this yes i have been three times 2008+2015+2019 my brother in-law lives in Frankfurt so very handy for FRA as well to which i go to every time we go.

Again Thanks

Regards Bill

Post Edited By BILLIUM on 14/07/2020 - 12:54:11
Posted by Hitman69 on 19 July 2020 - 17:06:16
Local Airport: MAN

Hi Billium,

I didn't realise when I replied there is an airfield at Speyer and that the museum site was actually part of the airfield, in fact many of the exhibits landed at the airfield for the last time and were the towed across the road. For that reason I am going to log my sightings at the museum as EDRY which is the ICAO code to the airfield but I will probably not against the which were in the museum. Also just in case you are not aware of it next time you visit if you follow the road that separated the airfield from the museum travelling east (I believe it is called Heinkelstrasse) the turn right with the river to your left outside one of the factory's is Starfighter 20+46. It isn't part of the museum, it is outside the Pfalz Flugzeuwerke but easily visable from the road. Looking at the PlaneLogger DB you don't have it down as a sighting (or maybe you just haven't got to that log book yet),

Good Luck


Posted by BILLIUM on 21 July 2020 - 16:14:26
Local Airport: MAN

Hi Steve

Thanks for that info on Speyer i will change things if needed on the DB

Regards Bill

Reply To Topic

You need to log in to post a reply to this topic.

<- Back To Forum